MyDaq Overview
•A hobby board that can be used to provide connection to all the components •Allows the user to control the direction and the state of the four channel outputs, and gains control over great deal of components •Can also be hooked up to a NI myDAQ- a programmable action controller •Ni myDaq-National Instruments programmable action controller •Used to measure live signals from any input attached •Powered through a USB cable •Can be connected to actuators and sensors •For mechanical measurements it can be used for temperature measurement, strain measurement, power, motion, and force measurements. •Can be used for resistance, inductive, and capacitive circuits, ac analysis and frequency response, can be added to bipolar junction transistors, and operational amplifier and filler circuits. |
MyStem board Specs
•6-24 Volts should be provided •4 output channels •Diode protection and thermal protection •Contains an I/O switch right near the power adapter input •400 hole breadboard •Numerous voltage outputs powering different sensors •The voltage of the output channels can be reversed to allow the motors to run in two different directions •Aux power connection •5V logic power supply MyDaq Specs
•ADC resolution: 16 Bit •Maximum sampling rate: 200kS/s •3.5mm stereo jack for audio input •Maximum working voltage for analog: 10.5V-AGND( Analog ground) •Overvoltage protection: 16V •Output FIFO size: 8191 samples •Digital I/O number of lines: 8 DIO •Direction control: Each line can individually be programmed as an input or an output. |
Arduino
The Arduino Uno is a microcontroller/ open source electronic platform which refers to the board and the software. It is used to connect numerous components such as LEDs, speakers and etc. it can also be integrated into countless projects such as robots, home automation systems, electronic safes and etc. |